Coax Cable Measurements

Contents

1. What is Return Loss:
Return loss is a measure of VSWR (Voltage Standing Wave Ratio), expressed in decibels (db). The return-loss is caused due to impedance mismatch between two or more circuits. For a simple cable assembly, there will be a mismatch where the connector is mated with the cable. There may be an impedance mismatch caused by nick or cuts in a cable. At microwave frequencies, the material properties as well as the dimensions of the cable or connector plays important role in determining the impedance match or mismatch.

A high value of return-loss denotes better quality of the system under test (or device under test).

For example, a cable with a return loss of 21 db is better than another similar cable with a return loss of 14 db, and so on.

2.Equipment required to measure return-loss of a co-axial cable:z

A co-axial cable is chosen to measure the return-loss for study purpose. Typically, for a device or a system, return-loss is measured at the input or at the output. The following equipment are used to measure the return loss of a co-axial cable at microwave frequencies:

Frequency source
Network Analyzer (either a scalar network analyzer or a vector network analyzer)
Detector with calibration source.
Reflection bridge
Co-axial Short
Cable under test (this could be any device under test)
A 10dB attenuator (optional, but recommended).

Cable Loss Measurement

3.The Measurement of Co-axial cable losses:
The measurement process consists of calibrating the test set-up for insertion and return-loss. If you have dual channel network analyzer, both insertion and return losses can be measured simultaneously. You can also measure insertion and return losses separately as is done here.

3.a Insertion loss Measurement:

Step 1. Set the sweep source to the required frequency range. Make sure that the output of the sweep source is within the desired amplitude limits, otherwise, it may saturate the detector head and any measurements taken would not be accurate. You may use an attenuator at the output of the sweep source to mitigate any problem that may arise due to mismatch between the cable under test and the sweep source.

It is recommended to use a 10 dB attenuator for this purpose. For example, you can set the values as below:

Sweep frequency (measurement frequency):

100MHz - 2.3 GHz; Sweep power: 12 dBm

Note: Also, make sure that you are measuring same impedance. For example, if the cable is 50Ohm, and the Sweep generator output is 75 Ohm, you need to use a 50 to 75 Ohm impedance matching device.

Courtesy: RFCables.org

Coax Cable Measurements - Continued

Step 2: Calibrate the test system by connecting as shown in the figure 1, bypassing the cable under test. Calibration is nothing but setting a reference line taking all stray measurement errors into consideration.

Step 3: Now you have done the equipment calibration, connect the cable as shown in the figure 2, without disturbing any other parameters such as sweep power output or the attenuator value. The trace in the network analyzer display now shows the Insertion loss of the cable against the frequency.

Courtesy: RFCables.org

Checkout full article at Tutorialsweb.com Coax Cable Measurements