How to disassemble and sharpen the blade of the honda lawn mower
To get a nice, clean lawn your mower needs to be able to cut the lawn clean when mowing. This guide will guide you on how to check and sharpen the blades of your honda mower to make sure your machine will cut through the grass blades instead of bruising and breaking them.
To get a nice and clean lawn your mower needs to be able to cut the lawn clean when mowing. This guide will guide you on how to check and sharpen the blades of your honda mower to make sure your machine will cut through the grass blades instead of bruising and breaking them.
disassemble and sharpen lawn mowers blades
>> When should I maintain the honda lawn mower
>> Honda lawn mower and frequently asked questions
>> How often should we sharpen the lawn blade knife
Remove blade from honda lawn mower
1. Disconnect spark plug wire to prevent accidental start.
2. Lift the lawn mower upwards so the carburetor is facing up to avoid flooding.
3. Mark the side of the blade outward with a permanent marker or spray paint. This way, you will know how the blade will be installed after sharpening.
4. Remove the blade latch. On some models, including all Twin Blade cutters, there are two bolts that hold the blade onto the motor shaft. Remove the bolts, but do not loosen the smaller center bolts. If the blade wants to spin, wedge a piece of wood between the blade.
5. Remove the blade, paying attention to the order of any washers or other accessories on the mounting bolt.
You have found the product like that, if not, please see here: best commercial zero turn mower
When need a new blade replace the blade
Now that you have access to the blades, check for any of the following signs of wear:
The edges of the blade cut thin.
The blade is bent.
Cut edges are cracked or deeply concave.
If you see any signs of wear, the blade should be replaced. The life of the honda mower blade can vary significantly depending on the local cutting conditions, so no time interval is set for replacement.
Use a sharp blade honda lawn mower
How to sharpen the blade of the lawn mower
The blade can be sharpened with a grinder or clamped to a chamfer and ground with a rotating shaft. The blade is made of mild steel and can be damaged by overheating: if you are using a motorized knife sharpener, let the blade cool down for a few seconds between grinders.
Always sharpen the top edge of the cutting edge.
Check the balance of the blade
Once the blade has been sharpened it needs a balance check: an unbalanced blade will cause strong vibrations that make it difficult for your cutter engine and the cutter operator. Blade balance is available, or you can hang the blade onto the nail and see if it tilts in either direction. Put some metal off the heavier (lower) side and check the balance again. When the blade is evenly on the nail or equalizer, it can be reinstalled.
Insert the blade back into the machine
Before you put the blade back in the lawn mower, you may want to take some time to remove any grass that has gathered on the underside of the deck. A nozzle or pressure sprayer will be able to remove most faded grass, while a putty knife can be used for tough spots.
Blade reinstallation is performed in reverse order of removal. Make sure any washers are installed in the correct order and tighten the blade bolts to the torque specified in your cutter manual.
